The models themselves are pretty easy (one part models, something I miss greatly from the MKI days), with little major clean up. There are a few things to bear in mind when building these (and all other servitors, as well as anything else that PP may chose to put on their new flight stands in the future).
Firstly, much like with GW's stands, the socket designed to accommodate the tip of the stand is not really fit for purpose. You will not get a decent connection and your models will keep breaking off the stand if you don't take some steps. Grab a large drill bit (I use one from an electric drill I use to build my scenery and tables). Use this to bore out a large, deep socket that fully encloses the top of the flight stand. This should lightly grip the model to make sure your connection is tight.
The next thing to bear in mind is that the flight stand is designed to fit in to the standard bases, which have an off center slot. If you look at the tab on the flight stand, you will notice that it does not cit central to the piece. Make sure you get it glued in the right way round to keep the stand central, or else your servitors will be flying very off centre.
The final issue I had was that the flight stands are made of a fairly "greasy" plastic which does not really take to superglue very well at all. I ended up using a combination of the depth of the sockets I drilled, and a small blob of blu tac (green stuff would be better but I didn't have any mixed and the blu tac was by my light). This will react oddly with the super glue and cause it to go off slightly and set faster. I do not advise doing this on most minis (though some swear by the trick) as it gives a weaker bond, but for a piece like this it helps set the glue slightly, allowing you to leave it to one side to properly bond while you work on other things.
You can see on the finished assembly, I pre based the model, as well as undercoated it as a whole, meaning the flight stand is not clear. Ultimately I am not too bothered about see through parts, and this army will not be a display/comp piece, so I want to make it as quick and painless as possible. Again, for a comp piece, I would have a very different method, but I want these guys on the table and painted ASAP.
In terms of painting, I chose to stick to the studio scheme. I don't tend to do this, and had visions of a khaki/weathered army. Ultimately, speed over ruled creativity, and I can drybrush metal when I have to.
The full six were painted from undercoat to finished in one sitting (I broke for lunch in the middle) and I think they took about three hours total. So thirty mins per ball, which isn't too bad. I have plenty more models to paint and really can't make this a major endevour . Overall I think they look fine on the table and the quicker I can get these done, the more time I can spend on the more important parts like the casters and the Prime Axiom.
I used the paint guide in the Cyriss book, but used washing and layering with some drybrushing to keep it quick and dirty. I will be blending on the casters as they will be the focus of the army, but for the rank and file I don't think they need it.
Hopefully there is some useful information that you can use in building and painting your Cyriss. Next up will some Angels I think.
No comments:
Post a Comment